1 Topic by sandcub1971

  • sandcub1971
  • Member
  • Offline
  • From: Phoenix, AZ
  • Registered: 2015-01-30
  • Posts: 129

Topic: Board issue

My extruder stepper motor stopped working. I swapped the wires from z axis to extruder drive and the extruder works and the z axis does not. I then put them back and just swapped which header the extruder and z axis motor where on and the problem always stays on which every motor is hooked the extruder header. I am pretty sure my board is bad, but I do not see a replacement board for it. Has anyone had to replace the board and if so where did you get the board?
Thanks in advance for your help.

2 Reply by sandcub1971

  • sandcub1971
  • Member
  • Offline
  • From: Phoenix, AZ
  • Registered: 2015-01-30
  • Posts: 129

Re: Board issue

I see in other post that some talk about using the Ramps 1.4. I looked into the kit with display, seems cheap in price. Has anyone else tried this board for a press, and if so how did it work for you?