1 Topic by craigunderhill

  • craigunderhill
  • Member
  • Offline
  • Registered: 2015-11-02
  • Posts: 67

Topic: Spare Parts

Where is a good place to buy spare parts? I have to replace the hot end on my Da Vinci 1.0. I don't need the entire extruder kit. Also, anyone know how long the barrel is on the stock hot end?  Thanks.

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Spare Parts

The only place to get authentic spare parts is from XYZ. There are no suppliers for parts for this machine other then them. It can use other parts from third parties but will require mods to do so. Just check around here as most things have been covered.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by craigunderhill

  • craigunderhill
  • Member
  • Offline
  • Registered: 2015-11-02
  • Posts: 67

Re: Spare Parts

Thanks.

4 Reply by craigunderhill

  • craigunderhill
  • Member
  • Offline
  • Registered: 2015-11-02
  • Posts: 67

Re: Spare Parts

Can someone show me a close up of where the red wires on the Da Vinci 1.0 contect to the hot end?  I know I probably can't fix, but I'd like to try. Thanks.

5 Reply by knucklbustr

  • knucklbustr
  • Member
  • Offline
  • Registered: 2014-10-15
  • Posts: 137

Re: Spare Parts

PM sent

DaV1.0  10/13
Repetier FW 0.92, Solidify3D