1 Topic by prpickett (edited by prpickett 2015-11-08 01:29:21)

  • prpickett
  • Member
  • Offline
  • Registered: 2014-08-18
  • Posts: 69

Topic: Network problem (Solved)

I am having intermittent connectivity issues with my Atlas. Using ethernet I can connect via putty however when I connect via browser (Chrome and Firefox) I sometimes get "err - connection refused". This happens intermittently but usually when I am either downloading a scan or test or when changing screens along the top control (SCAN CAMERA SETTINGS). If I reboot the atlas the problem usually goes away but returns eventually. I am using a raspberry pi 2 and have the latest update. I've been searching but haven't found a similar issue. I also run 2 printers via Octoprint on raspberry pis and am not having any issue connecting with them. I was in the middle of a scan on the last time it dropped and I am currently connected to the Atlas with putty and can issue commands but my browser has been trying to load the page for 20+ minutes without timing out or actually loading which is different than the err-connection refused. Any ideas?

DaVinci 1.0 w/ repetier firmware, Andy's Carriage, E3D V6, Filastruder #1956, Filawinder

2 Reply by hairu526

  • hairu526
  • Member
  • Offline
  • Registered: 2014-01-28
  • Posts: 494

Re: Network problem (Solved)

Hmm... I'll look into it.

3 Reply by prpickett

  • prpickett
  • Member
  • Offline
  • Registered: 2014-08-18
  • Posts: 69

Re: Network problem (Solved)

More data: Everything seemed to be working fine this morning. I was able to re-align lasers, change camera resolutions, perform auto calibration and run/view a test scan. Once I went back to settings and adjusted the image threshold value and pressed save, I got the connection refused screen.

DaVinci 1.0 w/ repetier firmware, Andy's Carriage, E3D V6, Filastruder #1956, Filawinder

4 Reply by hairu526

  • hairu526
  • Member
  • Offline
  • Registered: 2014-01-28
  • Posts: 494

Re: Network problem (Solved)

I found the problem.  The fix will be included in the next update.

5 Reply by hairu526

  • hairu526
  • Member
  • Offline
  • Registered: 2014-01-28
  • Posts: 494

Re: Network problem (Solved)

This issue has been resolved in the latest update.

6 Reply by prpickett

  • prpickett
  • Member
  • Offline
  • Registered: 2014-08-18
  • Posts: 69

Re: Network problem (Solved)

Thank you. Running for several hours now without any issues!

DaVinci 1.0 w/ repetier firmware, Andy's Carriage, E3D V6, Filastruder #1956, Filawinder