1 Topic by Solid (edited by Solid 2015-10-10 21:35:28)

  • Solid
  • Newbie
  • Offline
  • Registered: 2015-10-10
  • Posts: 2

Topic: Feature requests: WiFi network config UI, Disable Camera LED

It would be nice if the UI would allow specifying the SSID for connecting to non-broadcast networks.

The LED is bright enough through the clear-printed case that the camera detects the red light reflecting off a target and distorts the 3D map.  It can be disabled in a config file but it would be better to have a switch in the UI.

The web UI loading should not be dependent on camera detection, it should load regardless so that the user isn't troubleshooting a network connection when it is really the camera.

2 Reply by Night Pueo

  • Night Pueo
  • Newbie
  • Offline
  • Registered: 2015-03-23
  • Posts: 4

Re: Feature requests: WiFi network config UI, Disable Camera LED

What LED are you talking about?  The one on the Raspberry Pi itself? 

I think if the camera isn't detected, the FreeLSS program will not load.  I believe I ran into that problem when the camera ribbon cable pulled out of the connector on my Raspberry Pi.

3 Reply by hairu526

  • hairu526
  • Member
  • Offline
  • Registered: 2014-01-28
  • Posts: 494

Re: Feature requests: WiFi network config UI, Disable Camera LED

Solid, please open Issues on the Github site so that progress on your suggestions can be tracked properly.

https://github.com/hairu/freelss


Uriah