1 Topic by ne14pez

  • ne14pez
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 94

Topic: Looking for SD3 Motherboard (Printrboard Rev. E.) for cheap

my board is dead.  I could upgrade, but I would rather first try to get a cheap replacement.  Anybody have any old boards they want to sell?

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Looking for SD3 Motherboard (Printrboard Rev. E.) for cheap

hate to say it, but most people don't replace the board unless it dies, so finding a good "used" one is not going to be easy.

You would be far better off getting a Rumba, or even a Ramps for that matter.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1