Re: stops extruding after first layer?
Thanks you for the quick reply. I did just now find when I did a bed level test print where the head prints a big square line all the way around the bed edges that the plastic extruder carriage hits both the rear corner bed glass screws and pushes the bed down as it goes over the screws. New here but that does not seem right. Correct?
If your slicer is calibrated to your bed dimensions then it should not let you slice a model that goes outside of those dimensions. I also should state that it should always start in the center or near it with exception to a model such as this one that obviously starts on the edges. It sounds like your true bed center maybe offset as well some how. Either in the slicer or in firmware. Since you are using all stock I don't really see how that can happen. When you print very small objects like the demo birdbath, does it start in the middle of the bed or is it offset some what?
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.