26 Reply by sleepvideo

  • sleepvideo
  • Member
  • Offline
  • Registered: 2015-01-27
  • Posts: 30

Re: XYZWare Open Mod

sleepvideo wrote:

Hi,
Just tried installing the XYZware mod software. I don't remember what version. If I find the version number i will post. The first time I started up the software it ran fine. Then I tried starting it again so I could see if the software detected my printer and it crashed my PC. I just recovered from the Proxy hijack virus spyware so maybe that is the problem. But imediately after clicking on the software the screen sort of pixelates and then Blue screen crash. ;just seeing if anyone else is having issues.
P.S. i tried installing the XYZprinting version of XYZware and I keep getting error 87 on launch.

I have a Dell Mini PC WITH THE AMD processor and 4GB Ram.

John

w34 wrote:

Since several people have asked and it has been awhile since there has been a newer release, here is the latest version. Please remember it is still beta

http://voltivo.com/forum/davinci-softwa … e-open-mod

27 Reply by sleepvideo

  • sleepvideo
  • Member
  • Offline
  • Registered: 2015-01-27
  • Posts: 30

Re: XYZWare Open Mod

Oh, the version is XYZopenmod v 1.02

sleepvideo wrote:
sleepvideo wrote:

Hi,
Just tried installing the XYZware mod software. I don't remember what version. If I find the version number i will post. The first time I started up the software it ran fine. Then I tried starting it again so I could see if the software detected my printer and it crashed my PC. I just recovered from the Proxy hijack virus spyware so maybe that is the problem. But imediately after clicking on the software the screen sort of pixelates and then Blue screen crash. ;just seeing if anyone else is having issues.
P.S. i tried installing the XYZprinting version of XYZware and I keep getting error 87 on launch.

I have a Dell Mini PC WITH THE AMD processor and 4GB Ram.

John

w34 wrote:

Since several people have asked and it has been awhile since there has been a newer release, here is the latest version. Please remember it is still beta

http://voltivo.com/forum/davinci-softwa … e-open-mod

28 Reply by sleepvideo

  • sleepvideo
  • Member
  • Offline
  • Registered: 2015-01-27
  • Posts: 30

Re: XYZWare Open Mod

Hi again,
I am trying to run version 1.02 on my second computer which is a Dell Workstation with the intel and Nvida chips. I can not get it to work. It loads ok says that it connects to my printer. But I can not get the software to do anything. The software also runs sluggish. I click on an option and wait, wait, wait for it to update my selection. I wanted to use it for manually heating the bed. I was able to get the software to work on my AMD/ATI PC. As for the bed heating issue not the crashing issue. I just updated my printer's firmware, could that be the problem?
I really need a fix/help on this issue, please. Right now I have a print stuck to my bed and I want to heat the bed to see if I can get it off.

Thanks,
John

29 Reply by scotthay

  • scotthay
  • Member
  • Offline
  • From: Cincinnati, Ohio
  • Registered: 2014-08-30
  • Posts: 79

Re: XYZWare Open Mod

Somewhere on that voltivo site it lists the specific version of XYZ Ware you need to have installed and also the firmware it worked with at the time I believe. 

As far as a stuck print, if you have a can of duster sitting around try turning it upside down and spray the bottom of the print to try to freeze it, it might lift off.