<![CDATA[SoliForum - 3D Printing Community — Extruder drive rocking back and forth (HELP!)]]> https://www.soliforum.com/topic/9873/extruder-drive-rocking-back-and-forth-help/ Wed, 11 Feb 2015 15:31:32 +0000 PunBB <![CDATA[Re: Extruder drive rocking back and forth (HELP!)]]> https://www.soliforum.com/post/84696/#p84696 SOLVED! The issue was with the alignment of the gear in the extruder, As I had removed it to tighten the grub screw. The alignment was not right.
Align it properly and you are good to go.

]]> Wed, 11 Feb 2015 15:31:32 +0000 https://www.soliforum.com/post/84696/#p84696 <![CDATA[Extruder drive rocking back and forth (HELP!)]]> https://www.soliforum.com/post/84676/#p84676 Hi,
I have been facing this problem of the extruder drive rocking back and forth. Initially it was the grub screw that was loose.
I tightened it using a 1.5 allan key, but the problem still persisted.
I have also checked the continuity of the wiring, and that is fine too.
IS there something that i am doing wrong!
Kindly advice.

P.S. The printer worked when i got it and after a couple of prints failed.
Thanks

]]> Wed, 11 Feb 2015 12:56:20 +0000 https://www.soliforum.com/post/84676/#p84676