<![CDATA[SoliForum - 3D Printing Community — Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/topic/9863/which-direction-requires-adjustment-according-to-this-image/ Wed, 11 Feb 2015 10:46:54 +0000 PunBB <![CDATA[Re: Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84667/#p84667 Thanks.. Ugh.

How much of this is entirely removed by going to direct drive? :-) or perhaps better asked... How much of the need to adjust this from time to time is removed by going to direct drive. :-)

Thanks

(I have to ask.. do you mind PMing me and telling me what the fish line is for? :-)

]]> Wed, 11 Feb 2015 10:46:54 +0000 https://www.soliforum.com/post/84667/#p84667 <![CDATA[Re: Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84653/#p84653 Looks to me like you have the short motor belt way too loose. You're basically printing ovals. This is a Y axis problem for sure though. Just keep trying you'll get it right, it's a pain.

]]> Wed, 11 Feb 2015 05:40:23 +0000 https://www.soliforum.com/post/84653/#p84653 <![CDATA[Re: Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84646/#p84646 Sorry, I did figure that, but I was curious if it indicated a particular belt being out of alignment.

so I guess I'll go back through the process again.. it really is just hit or miss though. :-/

I think if the drive rod didn't slide back and forth things would be so much easier. :-/

]]> Wed, 11 Feb 2015 05:18:28 +0000 https://www.soliforum.com/post/84646/#p84646 <![CDATA[Re: Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84632/#p84632 This has been discussed at length but mostly this is caused by poor alignment of the y belts.

]]> Wed, 11 Feb 2015 04:19:22 +0000 https://www.soliforum.com/post/84632/#p84632 <![CDATA[Re: Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84631/#p84631 Doh.. thanks

yes, SD4.

]]> Wed, 11 Feb 2015 04:17:31 +0000 https://www.soliforum.com/post/84631/#p84631 <![CDATA[Re: Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84602/#p84602 What printer do you have? SD4

]]> Wed, 11 Feb 2015 03:14:51 +0000 https://www.soliforum.com/post/84602/#p84602 <![CDATA[Which direction requires adjustment? According to this image...]]> https://www.soliforum.com/post/84589/#p84589 I'm curious. I've spent a load of time trying to get my printer 'just so'. And it's been really good. But I'm wondering what adjustment I need to make for a print with gaps in these places.

The gaps are consistently in the back left and front right corners. (the picture shows this).

I don't really want to change my print head out until I have this fixed, one bug at a time.

Is this an issue of belt tension?

Thanks

Scott

(ignore the horrible build surface, please. :-)

]]> Wed, 11 Feb 2015 01:50:25 +0000 https://www.soliforum.com/post/84589/#p84589