<![CDATA[SoliForum - 3D Printing Community — Loose Set Screw?]]> https://www.soliforum.com/topic/9815/loose-set-screw/ Mon, 09 Feb 2015 04:01:06 +0000 PunBB <![CDATA[Re: Loose Set Screw?]]> https://www.soliforum.com/post/84204/#p84204 Me too mine was the y axis

]]> Mon, 09 Feb 2015 04:01:06 +0000 https://www.soliforum.com/post/84204/#p84204 <![CDATA[Re: Loose Set Screw?]]> https://www.soliforum.com/post/84203/#p84203 Is the part stuck down properly?
Also, have you tried other models?  I'd probably try a test cube to see if it prints higher without issues.

]]> Mon, 09 Feb 2015 03:39:12 +0000 https://www.soliforum.com/post/84203/#p84203 <![CDATA[Loose Set Screw?]]> https://www.soliforum.com/post/84199/#p84199 Is this sort of issue with prints indicative of a loose set screw on one of the axes? I've been trying to print this ring part, and it prints fine for the first 6-8mm but then gains an offset. In the case of the left part, it looks like a constant offset each layer.

I have to think it's either a loose set screw or something that causes an axis to miss steps every layer.

]]> Mon, 09 Feb 2015 02:42:26 +0000 https://www.soliforum.com/post/84199/#p84199