<![CDATA[SoliForum - 3D Printing Community — Setup Help Needed]]> https://www.soliforum.com/topic/9803/setup-help-needed/ Thu, 12 Feb 2015 00:44:38 +0000 PunBB <![CDATA[Re: Setup Help Needed]]> https://www.soliforum.com/post/84802/#p84802 satman49 wrote:

Have you updated the firmware? If not you will need to do so to take full advantage of the E3D. Do you know what motherboard you have, the stock MB or have you replaced it with a different one?

I have the stock older Sanguinololu motherboard, I'm guessing updating the firmware isn't much different than uploading a sketch to an Arduino.

Edit:
Firmware has been updated

]]> Thu, 12 Feb 2015 00:44:38 +0000 https://www.soliforum.com/post/84802/#p84802 <![CDATA[Re: Setup Help Needed]]> https://www.soliforum.com/post/84177/#p84177 Have you updated the firmware? If not you will need to do so to take full advantage of the E3D. Do you know what motherboard you have, the stock MB or have you replaced it with a different one?

]]> Mon, 09 Feb 2015 00:23:09 +0000 https://www.soliforum.com/post/84177/#p84177 <![CDATA[Setup Help Needed]]> https://www.soliforum.com/post/84131/#p84131 I've had my Solidoodle 2 for probably 1-2 years now, and still haven't managed to get everything setup right.  I recently put a E3D v6 hot end on it, so my question is, does anyone have any semi-easy to understand videos or instructions that would help with setting this up to get fairly good prints?

]]> Sun, 08 Feb 2015 20:32:51 +0000 https://www.soliforum.com/post/84131/#p84131