The first time I used their filament, it was the bright white. I mocked up a few tibial poly inserts for a presentation to a huge Asian Ortho manufacturer. I always get a little giddy when I can use my scrappy lil SD2 to make demo pieces for big wigs : )

Even though I've calibrated the extruder steps and the flow rate/thickness, I've always had issues with moist filament. After manual extrusions, I get another quarter inch or so of ooze if I wait.

Anecdotal evidence suggests that part of it is my official Solidoodle filament. After this spool I'm going back to Octave and never looking back : ) The Solidoodle stuff tends to curl and warp like not other.

I have a SD2 that gives me reasonably decent prints. I have always had a lingering problem with those little boogers of material that seem to gather at the start points. I've tweaked my print settings to try and keep it to a minimum, but I am still envious of those people who manage to get perfect prints right off of the build plate. I have done the stepper motor extrude calibration, the single wall print test calibration, and I've also done the xy stepper motor eeprom calibration and belt tension. Below is a pic. Thanks in advance for any help!