<![CDATA[SoliForum - 3D Printing Community — Noob questions]]> https://www.soliforum.com/topic/9682/noob-questions/ Fri, 06 Mar 2015 05:53:32 +0000 PunBB <![CDATA[Re: Noob questions]]> https://www.soliforum.com/post/88542/#p88542 The brand I use for printing is from Australia actually.

Brand: Aussie
Type: Instant Freeze
Strength: Extreme Hold

Also, I find this spray works best when applied right before printing. Not applied when cooled. That is when it is at its stickiest.

If you print without heating the bed, I get the best results with adhesion since I can literally spray this on 10 seconds before hitting Print.

It gets its best stick about half a minute to a minute in. At about 3 minutes it dries up and only serves its purpose midly when the bed is heated to 95c

]]> Fri, 06 Mar 2015 05:53:32 +0000 https://www.soliforum.com/post/88542/#p88542 <![CDATA[Re: Noob questions]]> https://www.soliforum.com/post/88514/#p88514 android78 wrote:

(only a few brands in Australia seem to work, and they're the expensive ones)

Could you share which ones you've used/recommend? I'm also in Aus, and it's always hard when people say to use certain brands and you can't source them locally, so it'd be great if you could share. This is day 3 of having my Press and I'm trying to remedy the adhesion problem.

]]> Fri, 06 Mar 2015 00:58:44 +0000 https://www.soliforum.com/post/88514/#p88514 <![CDATA[Re: Noob questions]]> https://www.soliforum.com/post/83193/#p83193 I just used warm water to clean the glass.  Obviously you remove it from the printer first. 
Once clean, used a liberal spray of hairspray (only a few brands in Australia seem to work, and they're the expensive ones) and then slide the glass back in.  The good thing with hair spray is that you just rinse under warm water to remove it when it gets messed up.

]]> Wed, 04 Feb 2015 20:19:31 +0000 https://www.soliforum.com/post/83193/#p83193 <![CDATA[Re: Noob questions]]> https://www.soliforum.com/post/83134/#p83134 Thanks! i didn't know about the software

]]> Wed, 04 Feb 2015 04:54:35 +0000 https://www.soliforum.com/post/83134/#p83134 <![CDATA[Re: Noob questions]]> https://www.soliforum.com/post/83123/#p83123 Z calibration doesn't work in Soliprint 1.1. Use Soliprint 1.0 instead.

Try some acetone on the glass bed?

]]> Wed, 04 Feb 2015 04:23:35 +0000 https://www.soliforum.com/post/83123/#p83123 <![CDATA[Noob questions]]> https://www.soliforum.com/post/83122/#p83122 How can i clean the glass bed? and why  I can't run the z calibration? english is not my natal language, it says something about z sensor being pressed, anybody could explain me?

]]> Wed, 04 Feb 2015 04:22:22 +0000 https://www.soliforum.com/post/83122/#p83122