<![CDATA[SoliForum - 3D Printing Community — Solidoodle 3 Diagonal Banding]]> https://www.soliforum.com/topic/9632/solidoodle-3-diagonal-banding/ Mon, 02 Feb 2015 06:54:48 +0000 PunBB <![CDATA[Re: Solidoodle 3 Diagonal Banding]]> https://www.soliforum.com/post/82845/#p82845 Thanks for your help. No,  it wasn't in vase mode but after I adjusted the vref dial at the back the results were amazing! Check out the picture below to see the difference. The post-vref adjustment cube is on the right.

]]> Mon, 02 Feb 2015 06:54:48 +0000 https://www.soliforum.com/post/82845/#p82845 <![CDATA[Re: Solidoodle 3 Diagonal Banding]]> https://www.soliforum.com/post/82670/#p82670 Did you print this in VASE mode?  That could be the reason you see the diagonal banding.

]]> Sun, 01 Feb 2015 03:46:31 +0000 https://www.soliforum.com/post/82670/#p82670 <![CDATA[Re: Solidoodle 3 Diagonal Banding]]> https://www.soliforum.com/post/82669/#p82669 It's called moire. You can combat this in a number of ways. The easiest (and cheapest) is to adjust the E VREF on the board. Be sure to use a non-conductive screwdriver and tune by ear as you extrude.
This has been covered quite a few times, so use the search feature. If you have any further questions, feel free to ask!

]]> Sun, 01 Feb 2015 03:45:55 +0000 https://www.soliforum.com/post/82669/#p82669 <![CDATA[Solidoodle 3 Diagonal Banding]]> https://www.soliforum.com/post/82651/#p82651 I've just installed my e3d v6 and new power supply and I've just done my first test print to calibrate the extrusion multiplier. Before I did this I levelled the bed,  did the PID tuning and calibrated my extruder steps per mm but I'm getting this diagonal banding on all sides of my cube.

I think that it might be a z-wobble problem but I'm not sure. Does anyone know what could be the cause of this?

]]> Sun, 01 Feb 2015 03:00:44 +0000 https://www.soliforum.com/post/82651/#p82651