SoliForum - 3D Printing Community — Has something changed in my firmware ?

Re: Has something changed in my firmware ?

null@example.com (xairflyer) — Sun, 01 Feb 2015 18:26:16 +0000

Thanks for replies, it was just unusual that every print I have done so far it always started at the bed front.
My serial starts 3F10APEU firmware 1.0.1 and software 1.1.34.7
I have seen firmware listed as 1.0.I or G but mine is definitely a 1

Re: Has something changed in my firmware ?

null@example.com (tonyno) — Sat, 31 Jan 2015 03:02:50 +0000

Stock everything here and have seen the purge line start differently sometimes. Seems normal.

Re: Has something changed in my firmware ?

null@example.com (carl_m1968) — Sat, 31 Jan 2015 02:05:11 +0000

Different models will start in different places. It all depends on how the slicer decides to best optimize the tool path. Now if the purge line is starting different then yes there could have been an update. But as long as it is printing, does it really matter how it starts?

I think it all just depends on how the slicer decides to start the run.

Has something changed in my firmware ?

null@example.com (xairflyer) — Sat, 31 Jan 2015 01:53:36 +0000

Everything I have printed on my Da Vinci 1.0A since I got it last week, it has layed down the nozzle/print test by starting at the front of the bed, goes about 25mm before it starts to extrude, gets to about the middle where it then lays the next line inside the first towards the front of the bed.

Last night when I printed something it started about the middle of the bed, extruding towards the front of the bed, then next line back to the centre? effectively reversing what it done before.

Could have the software or firmware been updated without me knowing and so changing this?