SoliForum - 3D Printing Community — Replacing Da Vinci 1.0A Head Thermistor (Stock firmware)

Re: Replacing Da Vinci 1.0A Head Thermistor (Stock firmware)

null@example.com (carl_m1968) — Fri, 30 Jan 2015 22:35:23 +0000

graciaj wrote:

I'll try that, thanks!
Found this on ebay:
100K High Stability NTC Thermistor 1.25mm RepRap Prusa Mendel Bed and Hot End

I am pretty sure that would work.

Re: Replacing Da Vinci 1.0A Head Thermistor (Stock firmware)

null@example.com (graciaj) — Fri, 30 Jan 2015 22:21:58 +0000

I'll try that, thanks!

Found this on ebay:
100K High Stability NTC Thermistor 1.25mm RepRap Prusa Mendel Bed and Hot End

Re: Replacing Da Vinci 1.0A Head Thermistor (Stock firmware)

null@example.com (carl_m1968) — Fri, 30 Jan 2015 22:04:43 +0000

graciaj wrote:

Hello,
Does anyone know which thermistor would make a good replacement to the original?
(I refer to the head thermistor)
For what I've been reading thermistor temp table might vary from manufacturer to manufacturer as well as model.
I have stock firmware so wouldn't know how to update temp table in case I was using a thermistor other than the original.
Thanks!

If you just buy a generic 100k thermistor or EPCO equivalent it should be fine. I doubt very seriously that this company is using some name brand or special purpose thermistor on their $99 head.

Replacing Da Vinci 1.0A Head Thermistor (Stock firmware)

null@example.com (graciaj) — Fri, 30 Jan 2015 19:42:14 +0000

Hello,

Does anyone know which thermistor would make a good replacement to the original?

(I refer to the head thermistor)

For what I've been reading thermistor temp table might vary from manufacturer to manufacturer as well as model.
I have stock firmware so wouldn't know how to update temp table in case I was using a thermistor other than the original.

Thanks!