<![CDATA[SoliForum - 3D Printing Community — Proper way to change filament in repetier host?]]> https://www.soliforum.com/topic/9540/proper-way-to-change-filament-in-repetier-host/ Sat, 31 Jan 2015 13:44:48 +0000 PunBB <![CDATA[Re: Proper way to change filament in repetier host?]]> https://www.soliforum.com/post/82554/#p82554 How do I just get it to temp without running a print job?

]]> Sat, 31 Jan 2015 13:44:48 +0000 https://www.soliforum.com/post/82554/#p82554 <![CDATA[Re: Proper way to change filament in repetier host?]]> https://www.soliforum.com/post/82154/#p82154 Ok thank you very much.

]]> Thu, 29 Jan 2015 02:44:42 +0000 https://www.soliforum.com/post/82154/#p82154 <![CDATA[Re: Proper way to change filament in repetier host?]]> https://www.soliforum.com/post/81919/#p81919 hansen644 wrote:

New to repetier host here. How do I change my filament?  Is there a correct way?

Connect to the printer, go to manual tab, heat extruder to set temp. Once heated use manual extrude button at 100mm in reverse, or just use the release lever on the head and pull the filament out. The main thing is to make sure it is at full temp.

]]> Tue, 27 Jan 2015 21:29:33 +0000 https://www.soliforum.com/post/81919/#p81919 <![CDATA[Proper way to change filament in repetier host?]]> https://www.soliforum.com/post/81916/#p81916 New to repetier host here. How do I change my filament?  Is there a correct way?

]]> Tue, 27 Jan 2015 21:12:11 +0000 https://www.soliforum.com/post/81916/#p81916