<![CDATA[SoliForum - 3D Printing Community — Sticking issue during z calibration]]> https://www.soliforum.com/topic/9478/sticking-issue-during-z-calibration/ Sun, 25 Jan 2015 04:19:09 +0000 PunBB <![CDATA[Re: Sticking issue during z calibration]]> https://www.soliforum.com/post/81428/#p81428 Check out the "sticky" on calibrating the press, or SD's getting started page for the press. You may have to shut down everything, unplug usb cable and start over. sending a reset g-code sometimes helps, it is somewhere in these posts. It's not the glue that's the problem, it's the printer and software. Hairspray is more forgiving.

]]> Sun, 25 Jan 2015 04:19:09 +0000 https://www.soliforum.com/post/81428/#p81428 <![CDATA[Re: Sticking issue during z calibration]]> https://www.soliforum.com/post/81426/#p81426 Switched to hair spray and the plastic is adhering much better.

]]> Sun, 25 Jan 2015 04:10:19 +0000 https://www.soliforum.com/post/81426/#p81426 <![CDATA[Sticking issue during z calibration]]> https://www.soliforum.com/post/81401/#p81401 I've tried 3 different brands of glue stick and none of the extruded filament is staying on the glass bed. 

I've tried Elmer's washable school glue (disappearing purple), Elmer's extra strength glue stick and Scotch craft stick.  I wash the bed between attempts and apply the glue when the bed is cool.  I also remove the filament hanging on the nozzle.  Attached is a photo of the filament just staying on the nozzle after a z calibration attempt.

Any thoughts on what I should try next?

]]> Sun, 25 Jan 2015 01:25:01 +0000 https://www.soliforum.com/post/81401/#p81401