https://www.soliforum.com/topic/9477/may-not-be-a-real-issue-z-limit-switch/ Fri, 08 May 2015 15:39:30 +0000 PunBB https://www.soliforum.com/post/95199/#p95199 Have you updated your printer firmware or repetier since it stopped doing that? I'm not sure which one handles the specific steps in the homing sequence, but whichever one it is probably changed. The sequence usually homes an axis at a faster speed and then slows down and homes again for accuracy.

]]> Fri, 08 May 2015 15:39:30 +0000 https://www.soliforum.com/post/95199/#p95199 https://www.soliforum.com/post/95195/#p95195 Did you end up resolving this issue?

]]> Fri, 08 May 2015 14:57:59 +0000 https://www.soliforum.com/post/95195/#p95195 https://www.soliforum.com/post/81399/#p81399 I just noticed that when I home the Z axis, it used to home then sort of bounce off the switch and then home for real. Now it just  stops dead when it hits the switch.

]]> Sun, 25 Jan 2015 00:35:18 +0000 https://www.soliforum.com/post/81399/#p81399