<![CDATA[SoliForum - 3D Printing Community — OctoPi?]]> https://www.soliforum.com/topic/9327/octopi/ Tue, 20 Jan 2015 16:38:59 +0000 PunBB <![CDATA[Re: OctoPi?]]> https://www.soliforum.com/post/80462/#p80462 Relevant posts to fix auto-leveling in other software:
http://www.soliforum.com/post/80457/#p80457
http://www.soliforum.com/post/80461/#p80461

The default startup gcode is missing G29 after the home xy, G28.

G21; set mm units
G90; set absolute coord
G28 X0 Y0; home x and y
G29; z probe bed
G92 E0; reset extrusion
]]> Tue, 20 Jan 2015 16:38:59 +0000 https://www.soliforum.com/post/80462/#p80462 <![CDATA[Re: OctoPi?]]> https://www.soliforum.com/post/80066/#p80066 That's the same issue I have with Repetier host.  Would be nice to find a fix.

]]> Mon, 19 Jan 2015 02:11:19 +0000 https://www.soliforum.com/post/80066/#p80066 <![CDATA[OctoPi?]]> https://www.soliforum.com/post/80057/#p80057 Has anyone got the Press to run off of a Raspberry Pi yet?  I set up OctoPi, but every time it prints, it prints in the air a few mm off of the bed.  It would be nice if the auto level worked too.

]]> Mon, 19 Jan 2015 01:23:23 +0000 https://www.soliforum.com/post/80057/#p80057