SoliForum - 3D Printing Community — sticking to bed help

Re: sticking to bed help

null@example.com (hansen644) — Sat, 10 Jan 2015 16:32:48 +0000

I have a chip resetter from wctek

Re: sticking to bed help

null@example.com (tonyno) — Sat, 10 Jan 2015 16:05:13 +0000

If you have stock soft/firmware, how are you changing the temps?

Re: sticking to bed help

null@example.com (carl_m1968) — Sat, 10 Jan 2015 04:42:56 +0000

I would not go above 120. Its more about the beds ABS substructure than the actual heater.

Re: sticking to bed help

null@example.com (hansen644) — Sat, 10 Jan 2015 04:22:45 +0000

ok thanks. what is the max temp I can set the bed at and be safe it will not damage the bed heater?

Re: sticking to bed help

null@example.com (carl_m1968) — Sat, 10 Jan 2015 04:11:04 +0000

hansen644 wrote:

Hi I am trying to print a quadcopter and its edges go all the way to the edges of the bed. Can not seem to get the front left corner layers to stay stuck to the bed after a few layers it warps up. I have bed temp set at 106 and filament 225. I have tried glue and also hairspray on the bed with no luck. Also have tried making up some abs slurry but same problem and also tired printing it on a raft and the raft also does the same thing in that area.

Try a higher bed temp. I never use less than 110 and most of the time 115.

Re: sticking to bed help

null@example.com (hansen644) — Sat, 10 Jan 2015 04:10:39 +0000

Note: I am using Stock xyz firm and software.

sticking to bed help

null@example.com (hansen644) — Sat, 10 Jan 2015 04:09:53 +0000

Hi I am trying to print a quadcopter and its edges go all the way to the edges of the bed. Can not seem to get the front left corner layers to stay stuck to the bed after a few layers it warps up. I have bed temp set at 106 and filament 225. I have tried glue and also hairspray on the bed with no luck. Also have tried making up some abs slurry but same problem and also tired printing it on a raft and the raft also does the same thing in that area.