Print Area: W 159 D 150 H 140 (might be more or less depending on your specific setup)

Home X and Y are set to Max
Home Z is set to Min

HAS DUMP AREA (OFF)

X-Min 0 X-MAX (159 or higher;it will hit a endstop regardless past this point) BL 0
Y-Min 0 X-Max (150 or higher;it will hit a endstop regardless past this point) BF 0

Make sure your Slic3r is set for a 150x150 "NOT" 159x150 BED SIZE. 

Auto-Arrange and Print away.

I have done some more troubleshooting which involved re-installing everything from scratch, including Windows to make sure everything is "clean".

I think I will rule out Repetier at this stage, I'm still experiencing problems after the re-install and I now think it's the printer itself that creates problems.

I will contct Solidoodle and see what they say about this.

It might have slipped, but it's printing just fine from Pronterface, that sort of rules out the laptop or the OS itself I believe.

Clearing out repetier can be a hassle. All settings are stored in the windows registry under CURRENT_USER/Software/Repetier. so you may have to go in and delete that, then start repetier again and re-do the profiles.

Edit: I see this is a fresh install. Try clearing out the repetier settings and re-doing them from scratch. Also, make sure you are not running anything in the background while printing. This can cause pauses. I run mine off my linux server which doesn't do much aside from file hosting and some light web hosting.

If all of that fails, you may want to either pick up a cheap dedicated machine or a control panel. I am backing the VikiLCD on kickstarter. it will take some soldering but looks really slick. Check the thread here: http://www.soliforum.com/topic/796/new-lcd/

The too many objects error is common and does not prevent printing. For some reason Repetier does not want to auto-arrange objects, but this does not prevent manual arrangement.

I don't know about windows 8 and any problems it may have. What port speed do you have it set to?

The same setting as in Pronterface (250000).
This is also the setting I used one the "old" computer and it worked fine there with Windows 7.

I don't know about windows 8 and any problems it may have. What port speed do you have it set to?

I'm having some issued with my printer which I'm not able to figure out, hopefully someone can point me in the right direction.

I started with a default install (Pronterface & Skeinforge) and this worked fine. Due to some issues with the walls on my print I wanted to try out Repetier & Slic3r, especially to get higher resolution on the prints.

Repetier worked fine until I messed up the profiles when trying to get more decent prints.

I ended up installing everything (Repetier 0.82 with the attached Slic3r) from scratch on a laptop (Windows 8) and now I'm having a hard time getting it to work. Obviosly I thought the problem was related to Windows 8 (previous computer was running Windows 7), but after installing Pronterface & Skeinforge I have changed my mind.
It's working with the standard Solidoodle installation.

I have two issues with Repetier:
1: When adding STL I get an error message telling me: "Too many objects on printer bed for automatic packing"
This error turned up after changing the printer settings from the default to what is recommended for the Solidoodle printer.

2: Slicing works fine and all controls of the printer is working as they should. However, after starting the print it stops after a period of time.
The time it takes before it stops varies from print to print.

I have tried different STL's with no change.

From what I have read I believe Repetier stores settings in the Windows registry and therefore it's very difficult to remove settings and start from fresh.
Is it possible at all to get rid of these settings without re-installing windows?

Hope someone can help with this since it's getting quite frustrating.