<![CDATA[SoliForum - 3D Printing Community — OOPs]]> https://www.soliforum.com/topic/8983/oops/ Fri, 02 Jan 2015 14:36:45 +0000 PunBB <![CDATA[Re: OOPs]]> https://www.soliforum.com/post/77203/#p77203 wire10ga wrote:
wardjr wrote:
satman49 wrote:

Been there ,done that.

+1

+1 as well smile

+1...guilty as charged tongue

]]> Fri, 02 Jan 2015 14:36:45 +0000 https://www.soliforum.com/post/77203/#p77203 <![CDATA[Re: OOPs]]> https://www.soliforum.com/post/77201/#p77201 wardjr wrote:
satman49 wrote:

Been there ,done that.

+1

+1 as well smile

]]> Fri, 02 Jan 2015 14:14:12 +0000 https://www.soliforum.com/post/77201/#p77201 <![CDATA[Re: OOPs]]> https://www.soliforum.com/post/77139/#p77139 wardjr wrote:
satman49 wrote:

Been there ,done that.

+1

Guilty

]]> Thu, 01 Jan 2015 23:16:14 +0000 https://www.soliforum.com/post/77139/#p77139 <![CDATA[Re: OOPs]]> https://www.soliforum.com/post/77136/#p77136 satman49 wrote:

Been there ,done that.

+1

]]> Thu, 01 Jan 2015 23:01:50 +0000 https://www.soliforum.com/post/77136/#p77136 <![CDATA[Re: OOPs]]> https://www.soliforum.com/post/77130/#p77130 Been there ,done that.

]]> Thu, 01 Jan 2015 22:09:38 +0000 https://www.soliforum.com/post/77130/#p77130 <![CDATA[Re: OOPs]]> https://www.soliforum.com/post/77127/#p77127 Pobody's Nerfect!

]]> Thu, 01 Jan 2015 21:22:21 +0000 https://www.soliforum.com/post/77127/#p77127 <![CDATA[OOPs]]> https://www.soliforum.com/post/77125/#p77125 It has been said we should learn from our mistakes. And it is even better to learn from the mistakes of others.
So in that vain I post a couple of stupid mistakes I recently made with my printer.
1) Hardware  when using a magnetic tip driver with interchangeable bits make sure the bit stays with the screwdriver after adjusting the set screws in the pulleys.  I happily adjusted a pulley attempted a test print and immediately heard a horrible sound the bit had stayed in the set screw jambed against the back wall of the printer and limited y movement to half a turn on the back rod. Duh I should know better.
2) software  it seemed the changes I made to Slic3r were not changing. Well it helps if you change the same profile that the program is using . 

OK I feel stupid and laugh if it makes you feel better.
so I hope this post either helps someone from repeating my error and or gives someone a good laugh.
Tin

]]> Thu, 01 Jan 2015 21:11:45 +0000 https://www.soliforum.com/post/77125/#p77125