SoliForum - 3D Printing Community — Squeak from the passive side front to back rod..

Re: Squeak from the passive side front to back rod..

null@example.com (slimstar2) — Tue, 30 Dec 2014 23:45:55 +0000

I love the way you think Azerate

Re: Squeak from the passive side front to back rod..

null@example.com (AZERATE) — Tue, 30 Dec 2014 16:34:19 +0000

I have had a squeak on the left quarter of my X rods for the last couple months. I haven't tried to get rid of it because I like that it gets on my wife's nerves

But...you could use white lithium grease

Re: Squeak from the passive side front to back rod..

null@example.com (jagowilson) — Tue, 30 Dec 2014 15:24:15 +0000

Yep that side just slides on Teflon blocks. Check out Lawsy's printable x and y carriages in hacks/mods if you want to go with bearings on all the rods instead.

Re: Squeak from the passive side front to back rod..

null@example.com (igor_zusev) — Tue, 30 Dec 2014 15:03:37 +0000

I had the Same problem with a new SD3 I uses DW40 on it. worked perfectly

Squeak from the passive side front to back rod..

null@example.com (jesseblnchrd) — Tue, 30 Dec 2014 05:38:27 +0000

Alright so I am getting a TERRIBLE squeak on the passive side (side without a motor) of the front to back carrier. So if you are looking at your Doodle, its the right side bar that runs from front of the machine to the back. Im pretty sure its where the carrier connects to the rod itself and rides, bc there isnt a bearing or anything there...just metal rod under plastic carrier. Has anyone replaced that with some sort of roller bearing or inline bearing like ALL THE OTHER rod connections have? It didnt start squeaking until I turned the speed up and I have lubed it and that works for a bit and it doesnt squeak ALL the time, just enough to be annoying.