SoliForum - 3D Printing Community — I did it, bowden extruder

Re: I did it, bowden extruder

null@example.com (satman49) — Thu, 01 Jan 2015 20:26:33 +0000

ok thanks

Re: I did it, bowden extruder

null@example.com (wardjr) — Thu, 01 Jan 2015 20:14:21 +0000

Try increasing your retraction speed and distance.

Re: I did it, bowden extruder

null@example.com (satman49) — Thu, 01 Jan 2015 19:58:30 +0000

update: I don't know why but prints come out stringy with the bowden setup. It should work just like the direct drive as all I did was mount the direct drive assembly remotely and added the bowden tube.(I left the lower half in place with the with the E3D )Z lift and retraction are set to one.

Re: I did it, bowden extruder

null@example.com (accusedmonk) — Wed, 31 Dec 2014 02:02:45 +0000

+1 I approve this mod! Id love to see pictures myself! I haven't tried speeding mine up any, but even at the same rate corners are more consistent.

Re: I did it, bowden extruder

null@example.com (elmoret) — Tue, 30 Dec 2014 21:53:00 +0000

Photos!

Re: I did it, bowden extruder

null@example.com (satman49) — Tue, 30 Dec 2014 21:52:19 +0000

yep , no problem, that ring just prevents the tube from coming out.

Re: I did it, bowden extruder

null@example.com (nbourg8) — Tue, 30 Dec 2014 20:09:19 +0000

I just installed my bowden e3d v6 extruder as well and did some test prints. My prints came out fine but I did forget to check if reverse extrusion is possible with the little black circular piece in place.

Are you able to reverse extrude the material out?

I did it, bowden extruder

null@example.com (satman49) — Tue, 30 Dec 2014 04:55:35 +0000

I got my Bowden extruder working finally. The only drawback I see so far is that it isn't as easy to change filament colors.Now I need to make another one so that I will be ready when I decide to get the Cyclops.