<![CDATA[SoliForum - 3D Printing Community — Z banding/wobble returned, now fixed]]> https://www.soliforum.com/topic/8929/z-bandingwobble-returned-now-fixed/ Sun, 28 Dec 2014 05:18:18 +0000 PunBB <![CDATA[Re: Z banding/wobble returned, now fixed]]> https://www.soliforum.com/post/76734/#p76734 Here is a good comparison of what consistent layers can do.  This is before and then after.

http://i.imgur.com/tCxYwoP.jpg

]]> Sun, 28 Dec 2014 05:18:18 +0000 https://www.soliforum.com/post/76734/#p76734 <![CDATA[Z banding/wobble returned, now fixed]]> https://www.soliforum.com/post/76728/#p76728 Shortly after installing my m3 Z axis rod, the banding that went away came back.  Finally after pouring over threads here, and watching this video specifically: https://www.youtube.com/watch?v=Ix8PHHisDuw, I have solved my issue with z banding/wobble.

Turns out that my m3 and coupler didn't flex as much as I thought they would to compensate for any flaws.  It was still stiff enough to flex the bed with at least the tolerance of the bushings.

This is the coupler, all I did was get them hand tight and backed off a bit.  I did add some lithium grease for good measure.

http://i.imgur.com/IGT6LFp.jpg

Here is what the issue looked like on every print:

http://i.imgur.com/PSVaK4d.jpg

Now after letting the bed just rest on the bottom of my nut trap:

http://i.imgur.com/n7kIJSV.jpg?1

]]> Sun, 28 Dec 2014 04:43:36 +0000 https://www.soliforum.com/post/76728/#p76728