<![CDATA[SoliForum - 3D Printing Community — Calibrate flow rate]]> https://www.soliforum.com/topic/8911/calibrate-flow-rate/ Mon, 29 Dec 2014 17:01:24 +0000 PunBB <![CDATA[Re: Calibrate flow rate]]> https://www.soliforum.com/post/76851/#p76851 It's much easier and accurate to download this: http://www.thingiverse.com/thing:271736

Then measure the wall, it should(as said) be the same as your extrusion multiplier.

]]> Mon, 29 Dec 2014 17:01:24 +0000 https://www.soliforum.com/post/76851/#p76851 <![CDATA[Re: Calibrate flow rate]]> https://www.soliforum.com/post/76839/#p76839 well. Used my dial calipers and found out the filament is extruding at .43 mm thick. then I printed a cbe with 2.5 mm wall thickness. piece came out at 2.94 wall thickness. Also see how the layers seprate sometimes. How do i prevent that?

]]> Mon, 29 Dec 2014 15:14:19 +0000 https://www.soliforum.com/post/76839/#p76839 <![CDATA[Re: Calibrate flow rate]]> https://www.soliforum.com/post/76838/#p76838 well. Used my dial calipers and found out the filament is extruding at .43 mm thick. then I printed a cbe with 25 mm wall thickness.

]]> Mon, 29 Dec 2014 15:14:13 +0000 https://www.soliforum.com/post/76838/#p76838 <![CDATA[Re: Calibrate flow rate]]> https://www.soliforum.com/post/76631/#p76631 Print a cube with 0 fill and 1 perimeter, stop before it gets to the top.  The wall thickness should match the extrusion width.   If it doesn't, change the extrusion multiplier.   If the wall needs to be 10% thinner,  reduce the extrusion multiplier 10%.

]]> Sat, 27 Dec 2014 14:56:15 +0000 https://www.soliforum.com/post/76631/#p76631 <![CDATA[Calibrate flow rate]]> https://www.soliforum.com/post/76622/#p76622 How do I get my flow rate right? I have very accurate calipers just need to know what to do.

]]> Sat, 27 Dec 2014 13:34:02 +0000 https://www.soliforum.com/post/76622/#p76622