<![CDATA[SoliForum - 3D Printing Community — Xyzware update]]> https://www.soliforum.com/topic/8903/xyzware-update/ Thu, 01 Jan 2015 04:12:13 +0000 PunBB <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/77082/#p77082 parentemv wrote:

Do you then import them back into xyzware to print.

yes I do.

]]> Thu, 01 Jan 2015 04:12:13 +0000 https://www.soliforum.com/post/77082/#p77082 <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/77049/#p77049 Do you then import them back into xyzware to print.

]]> Wed, 31 Dec 2014 19:58:12 +0000 https://www.soliforum.com/post/77049/#p77049 <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/77004/#p77004 I always run my stl files through netfabb. I use Sketchup and the exported stl's almost always need fixing.

]]> Wed, 31 Dec 2014 02:14:32 +0000 https://www.soliforum.com/post/77004/#p77004 <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/76997/#p76997 Do you run your models through netfabb and then import it back into xyzware to print?

]]> Wed, 31 Dec 2014 01:03:53 +0000 https://www.soliforum.com/post/76997/#p76997 <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/76966/#p76966 Most people block xyzware to prevent it doing an auto firmware update on the sly which would then prevent the use of cartridge resetters and disable the printer if you tried using a cartridge which had previously been reset.

]]> Tue, 30 Dec 2014 18:23:26 +0000 https://www.soliforum.com/post/76966/#p76966 <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/76943/#p76943 What do you use to send print job to printer? XYZWARE? Do you then load stl into xyzware after netfab? Why would blocking xyzware matter?

]]> Tue, 30 Dec 2014 11:34:56 +0000 https://www.soliforum.com/post/76943/#p76943 <![CDATA[Re: Xyzware update]]> https://www.soliforum.com/post/76703/#p76703 I just started using 1.1.33.3 today, done a few prints but don't see any difference in quality. It has a 'Auto Repair' option before slicing, I assume this uses Netfabb or some other tool but I haven't tried it as I run all my stl's through netfabb already, and I have my xyz.exe firewalled as I use a resetter and firmware 1.1.J.

]]> Sun, 28 Dec 2014 02:42:05 +0000 https://www.soliforum.com/post/76703/#p76703 <![CDATA[Xyzware update]]> https://www.soliforum.com/post/76553/#p76553 What if any benefit does xyzware v. 1.1.33.3 have over previous versions. Better prints? more printer control? Better slicing?

]]> Fri, 26 Dec 2014 18:03:24 +0000 https://www.soliforum.com/post/76553/#p76553