<![CDATA[SoliForum - 3D Printing Community — Help please! 2nd layer problem]]> https://www.soliforum.com/topic/8505/help-please-2nd-layer-problem/ Fri, 28 Nov 2014 17:25:18 +0000 PunBB <![CDATA[Re: Help please! 2nd layer problem]]> https://www.soliforum.com/post/73331/#p73331 thanks for your fast Response!

i think i found the solution for my Problem.
the Filament cartridge doesnt give enough Filament, so after some layers the printer´s head cannot move.

thank you for your help!

]]> Fri, 28 Nov 2014 17:25:18 +0000 https://www.soliforum.com/post/73331/#p73331 <![CDATA[Re: Help please! 2nd layer problem]]> https://www.soliforum.com/post/73319/#p73319 The only time that happened to me was when the printer's head was physically detained either by the cable length.
Does this happen every time?
What firmware are you using?

]]> Fri, 28 Nov 2014 14:14:28 +0000 https://www.soliforum.com/post/73319/#p73319 <![CDATA[Help please! 2nd layer problem]]> https://www.soliforum.com/post/73318/#p73318 Hello,

i always have the same Problem with printing the sampel.
The first layers looks fine but the 2nd is totally wrong.

i hope someone  can help me!


thanks
mersi

]]> Fri, 28 Nov 2014 14:05:47 +0000 https://www.soliforum.com/post/73318/#p73318