https://www.soliforum.com/topic/8282/strange-new-problem/ Tue, 11 Nov 2014 00:00:40 +0000 PunBB https://www.soliforum.com/post/71441/#p71441 yep that was it,  in EEprom config I doubled the x/y steps. Odd tho as I never had to do that before.THX

]]> Tue, 11 Nov 2014 00:00:40 +0000 https://www.soliforum.com/post/71441/#p71441 https://www.soliforum.com/post/71436/#p71436 Is it the steps / mm?

]]> Mon, 10 Nov 2014 22:33:20 +0000 https://www.soliforum.com/post/71436/#p71436 https://www.soliforum.com/post/71424/#p71424 I am doing some further testing. I just noticed that I can only move the the extruder manually in a 4in. x 4in. pattern That looks like my problem. It happened once before, I can't remember what I did to correct it.

]]> Mon, 10 Nov 2014 21:10:38 +0000 https://www.soliforum.com/post/71424/#p71424 https://www.soliforum.com/post/71418/#p71418 Did you check the firmware settings? I've found that flashing firmware always seems to make the code reset the eeprom. All my tweaks to calibration would disappear when I put new firmware on the system. (Though printing half size seems extreme, but maybe the steps/mm are half size :-).

]]> Mon, 10 Nov 2014 20:14:00 +0000 https://www.soliforum.com/post/71418/#p71418 https://www.soliforum.com/post/71413/#p71413 First I am using my old sang 1.2 board.I flashed the firmware as I changed thermistors.That seemed to where the trouble started. Now when load an object and slice it , it shows up in the gcode window correctly but when it starts to print it's on half size and only prints in the upper right quadrant .I have looked at the config H again and can't see any thing that might cause that.

]]> Mon, 10 Nov 2014 19:29:29 +0000 https://www.soliforum.com/post/71413/#p71413