SoliForum - 3D Printing Community — Newbie help request: Huge skew / offset on prints

Re: Newbie help request: Huge skew / offset on prints

null@example.com (tankut) — Mon, 03 Nov 2014 14:46:18 +0000

Tightening the left (y) belt and loosening the right (y) did the trick, thank you very much.. The waviness is also gone.

ust modeled a circular test object, next step is testing for correct aspect ratio..

( Was already doing the homing before print, but the head resets just before print anyway )

Re: Newbie help request: Huge skew / offset on prints

null@example.com (jagowilson) — Fri, 31 Oct 2014 00:02:38 +0000

Definitely printing too far from the bed. Biggest evidence of that is the wavy sides of your print where it didn't shift--your nozzle is clobbing into the plastic as it falls. Use an 8x11 sheet of paper to balance the bed, it should be smug, but should still move freely. I use colored construction paper because it's a tad more rigid but still has a thickness of 0.17mm which is the distance I aim for usually.

Now once you solve that, check your belts. Bass on the looks of it you've got a belt too loose--probably the one on the left, either the one running along the side of the printer or the one on the Y motor. I say that because it seems as though you're shifting to the right, and this was the exact same thing my SD4 did out of the box.

Also interesting you had to fix your endstops. Mine were pretty janked as well, mostly Z.

Re: Newbie help request: Huge skew / offset on prints

null@example.com (wire10ga) — Thu, 30 Oct 2014 22:30:29 +0000

You don't have to hit the HOME button before starting any print, Cause that is the 1st thing it tells the printer to do when you start your print. I've started a many of print with the head not in the home position before. Home has nothing to do with the problem shown. I would say to check if bed is level, then check nozzle height then check extrusion flow.

Re: Newbie help request: Huge skew / offset on prints

null@example.com (n2ri) — Thu, 30 Oct 2014 20:16:33 +0000

1st thing to do b4 starting any print after clicking connect button (all other setup has been done also) is click the home button in manual control panel or motors wont lock on position, as they dont know where they are. (still in off/neutral mode)

Re: Newbie help request: Huge skew / offset on prints

null@example.com (IronMan) — Thu, 30 Oct 2014 18:09:14 +0000

Check your Y drive pulleys to make sure all of the set screws are tight...

Other than that, hit the "Search" button in the menu bar above and search for "Y layer shift". You will find tons of topics and suggestions...

Newbie help request: Huge skew / offset on prints

null@example.com (tankut) — Thu, 30 Oct 2014 16:55:21 +0000

After following all the initial setup/calibration guides (and repairing the stopper contact switches) we've managed to get the new SD4 running.

Thing is, we haven't managed to print a simple test STL yet. The head apparently moves freely and without glitches on all axes in manual mode in Repetier, but the prints come out all skewed in Y, by around a huge 5-7 mm every slice (image attached).

I've tested the slic3r (v1.1.7) gcode output online ( 3dgeni.us -> gCodeViewer ) and it looks OK.

What am I doing wrong, any pointers?