<![CDATA[SoliForum - 3D Printing Community — Slic3r share your Configuration]]> https://www.soliforum.com/topic/8159/slic3r-share-your-configuration/ Thu, 30 Oct 2014 21:27:05 +0000 PunBB <![CDATA[Re: Slic3r share your Configuration]]> https://www.soliforum.com/post/70192/#p70192 Ghostling wrote:

in my experience, different filament need to print with different temperatures. i just figure it out with trial and error.
My white ABS i print at 210, black i print at 200.... bed always at 100.
too low i get bad lamination, too high i get bad curling...


+1 Red seems to melt easyest for some reason

]]> Thu, 30 Oct 2014 21:27:05 +0000 https://www.soliforum.com/post/70192/#p70192 <![CDATA[Re: Slic3r share your Configuration]]> https://www.soliforum.com/post/70176/#p70176 in my experience, different filament need to print with different temperatures. i just figure it out with trial and error.
My white ABS i print at 210, black i print at 200.... bed always at 100.
too low i get bad lamination, too high i get bad curling...

]]> Thu, 30 Oct 2014 19:26:20 +0000 https://www.soliforum.com/post/70176/#p70176 <![CDATA[Re: Slic3r share your Configuration]]> https://www.soliforum.com/post/70135/#p70135 really depends what your printing so need to include that with presets. I have 24 different presets so far and change or add often to achieve best results on item printed and I do several dif types. some customer orders through  my 3Dhubs.com hub

]]> Thu, 30 Oct 2014 03:25:20 +0000 https://www.soliforum.com/post/70135/#p70135 <![CDATA[Re: Slic3r share your Configuration]]> https://www.soliforum.com/post/70074/#p70074 Looks to me like your temp it too high.  I run about 200 for extruder, 85 for bed, using ABS.
I use 2 perimeters, 15% infill, 2 tops, 2 bottoms for printing at .3mm.

]]> Wed, 29 Oct 2014 12:39:54 +0000 https://www.soliforum.com/post/70074/#p70074 <![CDATA[Slic3r share your Configuration]]> https://www.soliforum.com/post/70045/#p70045 I have a solidoodle4 and use Slic3r. I was wondering if anyone would be will to export their configuration (one that works good)and share it with me. I am getting ok prints but think they could be better, hopping to look at other configurations and get ideas on what to try and change. I have attached one that I have been using if someone wants to look it over and give suggestions.
Thanks
Chad

]]> Wed, 29 Oct 2014 00:13:30 +0000 https://www.soliforum.com/post/70045/#p70045