<![CDATA[SoliForum - 3D Printing Community — Cleaning the bed]]> https://www.soliforum.com/topic/7955/cleaning-the-bed/ Fri, 17 Oct 2014 19:08:40 +0000 PunBB <![CDATA[Re: Cleaning the bed]]> https://www.soliforum.com/post/68909/#p68909 I have found that a razor scraper (http://www.homedepot.com/p/Stanley-1-1- … /202262010) makes it even easier and faster to get the bed clean. I moisten the bed with a wet paper towel... just lay it on top for a few seconds ... don't have to swish it around or rub or anything... then I use the scraper to scrape off the glue, using the paper towel i just took off the bed to wipe the razor clean between passes. A new sharp blade (which will last basically forever) shaves closer than a Trac IV razor. smile

]]> Fri, 17 Oct 2014 19:08:40 +0000 https://www.soliforum.com/post/68909/#p68909 <![CDATA[Re: Cleaning the bed]]> https://www.soliforum.com/post/68689/#p68689 ... Wait for the glass to cool, use a wet paper towel. The xyz website shows a video of it. Works great.

]]> Wed, 15 Oct 2014 03:42:03 +0000 https://www.soliforum.com/post/68689/#p68689 <![CDATA[Cleaning the bed]]> https://www.soliforum.com/post/68224/#p68224 I finally took the plunge & bought the daVinci printer .
So far, I have used the stock software & filament to print a few small objects I designed on tinkercad.
So far so good.
What is the bestway to clean the glass bed?
no problems so far with warping etc

Thanks

]]> Fri, 10 Oct 2014 12:58:05 +0000 https://www.soliforum.com/post/68224/#p68224