<![CDATA[SoliForum - 3D Printing Community — Diagonal Pattern Issue]]> https://www.soliforum.com/topic/7897/diagonal-pattern-issue/ Sat, 04 Oct 2014 18:36:34 +0000 PunBB <![CDATA[Re: Diagonal Pattern Issue]]> https://www.soliforum.com/post/67628/#p67628 BTW, this is a SD2

]]> Sat, 04 Oct 2014 18:36:34 +0000 https://www.soliforum.com/post/67628/#p67628 <![CDATA[Re: Diagonal Pattern Issue]]> https://www.soliforum.com/post/67627/#p67627 Thanks.

First I tested it and it was ~190mV.
Then I printed the test cube at 150mV, 170mV, 200mV, 230mV and 270mV. The results were always the same.
Should I try even higher or lower? Or should I try smaller increments?

]]> Sat, 04 Oct 2014 18:36:17 +0000 https://www.soliforum.com/post/67627/#p67627 <![CDATA[Re: Diagonal Pattern Issue]]> https://www.soliforum.com/post/67622/#p67622 Moire. You can use a ceramic or other non-conductive screwdriver to adjust the VREF on the board (the one that says E). Only a tiny turn is needed, though.

]]> Sat, 04 Oct 2014 17:08:52 +0000 https://www.soliforum.com/post/67622/#p67622 <![CDATA[Diagonal Pattern Issue]]> https://www.soliforum.com/post/67621/#p67621 Heya,

A couple of days ago I started noticing these patterns on my prints. Any ideas what may cause this?

]]> Sat, 04 Oct 2014 17:00:12 +0000 https://www.soliforum.com/post/67621/#p67621