<![CDATA[SoliForum - 3D Printing Community — new PSU behaves weird]]> https://www.soliforum.com/topic/7732/new-psu-behaves-weird/ Sat, 20 Sep 2014 19:19:59 +0000 PunBB <![CDATA[Re: new PSU behaves weird]]> https://www.soliforum.com/post/66527/#p66527 well works now without a hitch, i dont know what happened during the night smile

]]> Sat, 20 Sep 2014 19:19:59 +0000 https://www.soliforum.com/post/66527/#p66527 <![CDATA[Re: new PSU behaves weird]]> https://www.soliforum.com/post/66470/#p66470 That means you either have a short, or the new PSU doesn't really output what it says it does and is going into overload protection.

Since it wasn't clear in the OP: This is not a PSU that was provided by Filastruder, Sungod sourced one himself.

]]> Fri, 19 Sep 2014 20:47:42 +0000 https://www.soliforum.com/post/66470/#p66470 <![CDATA[new PSU behaves weird]]> https://www.soliforum.com/post/66466/#p66466 Hey,

I just bought a new PSU for the motor (I have it separated from the heater circuit) I worked before with a PSU of the same specification but when I turn it on now the unit itself starts clicking in 1sec intervals and the motor moves only in pulses.
Im pretty sure I didnt confuse the polarity although to my knowledge it shouldn't matter anyway.
The voltage also jumps up and down but without load it shows 12V straight .

Is there anything obvious I overlooked?

]]> Fri, 19 Sep 2014 19:53:41 +0000 https://www.soliforum.com/post/66466/#p66466