SoliForum - 3D Printing Community — Printing problem

Re: Printing problem

null@example.com (hanlun.wong) — Fri, 19 Sep 2014 09:06:15 +0000

Dear All,

thank you very much for valuable advice. i will try all the advices.

for sure, i had already calibrated the extruder. but some suggestion still not yet try.

thank you

null@example.com (IronMan) — Thu, 18 Sep 2014 20:23:32 +0000

wire10ga wrote:

Have you done the extruder calibration yet?

These should help you:

http://www.soliforum.com/topic/2962/dis … p-filling/
Note that relating to this last link, if you are using a .4mm nozzle, the extruded strand width should be around 0.48mm...

null@example.com (wire10ga) — Thu, 18 Sep 2014 17:09:18 +0000

Have you done the extruder calibration yet?

null@example.com (n2ri) — Thu, 18 Sep 2014 13:18:11 +0000

wheres the infil? is it turned off in slicer? need at min 15% I use 30 on most settings

null@example.com (hanlun.wong) — Thu, 18 Sep 2014 12:00:56 +0000

hi,

Please advice what is the problem of my printing, please refer to attachment

I use PLA, the wall is 2mm, but the filament not joining.

Please advice