<![CDATA[SoliForum - 3D Printing Community — calibration cube]]> https://www.soliforum.com/topic/7623/calibration-cube/ Mon, 08 Sep 2014 04:10:34 +0000 PunBB <![CDATA[Re: calibration cube]]> https://www.soliforum.com/post/65735/#p65735 grob wrote:

Normally I use a plain 20mm cube (solid), and instruct slic3r to perform about 2 bottom layers (make sure it sticks...), 0 top layers, just 1 perimeter and 0% infill.

I usually create this profile from my existing normal profile, so it picks up all the other settings identically for a fair comparison!

+1

]]> Mon, 08 Sep 2014 04:10:34 +0000 https://www.soliforum.com/post/65735/#p65735 <![CDATA[Re: calibration cube]]> https://www.soliforum.com/post/65714/#p65714 Normally I use a plain 20mm cube (solid), and instruct slic3r to perform about 2 bottom layers (make sure it sticks...), 0 top layers, just 1 perimeter and 0% infill.

I usually create this profile from my existing normal profile, so it picks up all the other settings identically for a fair comparison!

]]> Sun, 07 Sep 2014 23:48:20 +0000 https://www.soliforum.com/post/65714/#p65714 <![CDATA[Re: calibration cube]]> https://www.soliforum.com/post/65647/#p65647 ok found right box and test print came out to .41mm all 4 sides

]]> Sun, 07 Sep 2014 03:36:28 +0000 https://www.soliforum.com/post/65647/#p65647 <![CDATA[calibration cube]]> https://www.soliforum.com/post/65642/#p65642 is the right stl file a complete cube or an open top box? all I found was closed hollow cube and cant get Slic3r to stop making a raft, 10 layers bottom and 2 perimiters no matter how many times I try and reset save re-slice.

]]> Sun, 07 Sep 2014 02:32:15 +0000 https://www.soliforum.com/post/65642/#p65642