<![CDATA[SoliForum - 3D Printing Community — Multiple Printers on one PC]]> https://www.soliforum.com/topic/7363/multiple-printers-on-one-pc/ Mon, 18 Aug 2014 03:05:41 +0000 PunBB <![CDATA[Re: Multiple Printers on one PC]]> https://www.soliforum.com/post/63631/#p63631 When you connect up your Ramps will show up on a different COM port.
When you make your changes in configuration.h add a name.  I like to just use the board name so I call the Rumba "Rumba" and the Sang "Sang and the printer board well you get the idea.
But you will want to Note what COM port is which printer.

]]> Mon, 18 Aug 2014 03:05:41 +0000 https://www.soliforum.com/post/63631/#p63631 <![CDATA[Re: Multiple Printers on one PC]]> https://www.soliforum.com/post/63586/#p63586 Thanks!

So once I upload the Marlin firmware for the RAMPS board and fix the appropriate lines in configuration.h and upload, etc; then this new printer (Ord Bot) will appear somewhere?

]]> Sun, 17 Aug 2014 15:55:59 +0000 https://www.soliforum.com/post/63586/#p63586 <![CDATA[Re: Multiple Printers on one PC]]> https://www.soliforum.com/post/63582/#p63582 I haven't had any problems just run 2 instances of R-H at the same time.  You'll want to be careful with slicing while the other is printing. No different than slicing with only one printer while printing.

]]> Sun, 17 Aug 2014 15:35:45 +0000 https://www.soliforum.com/post/63582/#p63582 <![CDATA[Multiple Printers on one PC]]> https://www.soliforum.com/post/63577/#p63577 Those of you out there running more than one printer; how does RH deal with the 2 printer profiles?  I could not see anything in RH that was that obvious (dropdown choice) for selecting your printer.

Before I configure my second printer, I just want to be sure I don't wipe away the settings for my SD2!

]]> Sun, 17 Aug 2014 15:23:44 +0000 https://www.soliforum.com/post/63577/#p63577