<![CDATA[SoliForum - 3D Printing Community — Bad filament surface at higher temps]]> https://www.soliforum.com/topic/7338/bad-filament-surface-at-higher-temps/ Sat, 16 Aug 2014 20:45:49 +0000 PunBB <![CDATA[Re: Bad filament surface at higher temps]]> https://www.soliforum.com/post/63523/#p63523 Hmm. It would be good to know, not only for expected extrusion properties but also for safety!

]]> Sat, 16 Aug 2014 20:45:49 +0000 https://www.soliforum.com/post/63523/#p63523 <![CDATA[Re: Bad filament surface at higher temps]]> https://www.soliforum.com/post/63522/#p63522 Ah good to know.
I dont know what kind of plastic I have

]]> Sat, 16 Aug 2014 20:42:48 +0000 https://www.soliforum.com/post/63522/#p63522 <![CDATA[Re: Bad filament surface at higher temps]]> https://www.soliforum.com/post/63467/#p63467 This is pretty common with all ABS, though MG94 doesn't seem to do it until 200C or so. I am not certain if it is from moisture or melt fracture. Have you tried drying the pellets? What resin ID?

]]> Sat, 16 Aug 2014 03:35:55 +0000 https://www.soliforum.com/post/63467/#p63467 <![CDATA[Bad filament surface at higher temps]]> https://www.soliforum.com/post/63443/#p63443 Hey,

I have the issue that the surface of my ABS I bought from and injection molding company gets really rough when I extrude it over 175C. Its not really a problem it just looks weird.

I assume its an issue with that particular type of plastic, but I wanted to ask if anyone else has seen a similar thing with their extrusion.

]]> Fri, 15 Aug 2014 22:11:50 +0000 https://www.soliforum.com/post/63443/#p63443