https://www.soliforum.com/topic/7280/older-drivers-newer-board/ Wed, 13 Aug 2014 02:14:43 +0000 PunBB https://www.soliforum.com/post/63075/#p63075 Then put them back the other way and compare the pins.  You'll most likely find that two that go to the motors are reversed.  Pull those out of the plug and switch them (use a razor to lift the plastic tab and slide the wire out.

]]> Wed, 13 Aug 2014 02:14:43 +0000 https://www.soliforum.com/post/63075/#p63075 https://www.soliforum.com/post/63056/#p63056 I flipped it around and now I get nothing at all.

]]> Tue, 12 Aug 2014 20:40:17 +0000 https://www.soliforum.com/post/63056/#p63056 https://www.soliforum.com/post/63045/#p63045 The Pin out is labeled on the drivers, compare them side by side.  You may have them in backward or need to swap a couple wires on the motors.

]]> Tue, 12 Aug 2014 19:00:53 +0000 https://www.soliforum.com/post/63045/#p63045 https://www.soliforum.com/post/63043/#p63043 That doesn't seem to work.

]]> Tue, 12 Aug 2014 18:27:32 +0000 https://www.soliforum.com/post/63043/#p63043 https://www.soliforum.com/post/62871/#p62871 You need to adjust the VREF's

]]> Mon, 11 Aug 2014 02:45:46 +0000 https://www.soliforum.com/post/62871/#p62871 https://www.soliforum.com/post/62868/#p62868 I tried a little while ago and all I get is a high pitch whine and no movement.

]]> Mon, 11 Aug 2014 02:24:11 +0000 https://www.soliforum.com/post/62868/#p62868 https://www.soliforum.com/post/62864/#p62864 You should be fine swapping those out.

]]> Mon, 11 Aug 2014 01:44:20 +0000 https://www.soliforum.com/post/62864/#p62864 https://www.soliforum.com/post/62850/#p62850 The stepper driver for my extruder went bad on my Azteeg X3. Can I use a driver from my old Sanguinololu until I get around to ordering a new one? I know it will fit but I'm sure I would need to tweak some settings. Of course this happens when I actually *need* to print something to fix a car.

]]> Sun, 10 Aug 2014 22:57:05 +0000 https://www.soliforum.com/post/62850/#p62850