<![CDATA[SoliForum - 3D Printing Community — GP-35 Review]]> https://www.soliforum.com/topic/7142/gp35-review/ Thu, 31 Jul 2014 05:22:41 +0000 PunBB <![CDATA[Re: GP-35 Review]]> https://www.soliforum.com/post/61570/#p61570 At this point I do not have any numbers, but when I was extruding MG94 during the purge the filament was extruding faster. At least that is what I think. I plan to get some MG94 and compare the two at some point in the next 2 weeks. I will post an update when that happens.

]]> Thu, 31 Jul 2014 05:22:41 +0000 https://www.soliforum.com/post/61570/#p61570 <![CDATA[Re: GP-35 Review]]> https://www.soliforum.com/post/61568/#p61568 Looks good! Can you quantify "a tad slower"?

]]> Thu, 31 Jul 2014 05:03:02 +0000 https://www.soliforum.com/post/61568/#p61568 <![CDATA[GP-35 Review]]> https://www.soliforum.com/post/61567/#p61567 I recently bought 10 pounds of GP-35 pellets from http://3dsupplysource.com/, and loaded them into my Filastruder. They extrude just a tad slower than MG94, but still work great. Tolerances of + or - 0.05mm are still present. It is cheaper than MG94 which is good.

Pros
Cheaper than MG94
Tolerances of + or - 0.05mm

Cons
extrudes a bit slower than MG94 (still testing this, so this maybe inaccurate)

Here is a video of me printing with it. My printers not calibrated too well, and I apologize for the bad video quality in advance.
http://www.youtube.com/watch?v=qr-JH-17F5g

]]> Thu, 31 Jul 2014 05:01:12 +0000 https://www.soliforum.com/post/61567/#p61567