<![CDATA[SoliForum - 3D Printing Community — Solidoodle risers to store power supplies]]> https://www.soliforum.com/topic/7126/solidoodle-risers-to-store-power-supplies/ Fri, 01 Aug 2014 11:36:35 +0000 PunBB <![CDATA[Re: Solidoodle risers to store power supplies]]> https://www.soliforum.com/post/61686/#p61686 +1

]]> Fri, 01 Aug 2014 11:36:35 +0000 https://www.soliforum.com/post/61686/#p61686 <![CDATA[Re: Solidoodle risers to store power supplies]]> https://www.soliforum.com/post/61664/#p61664 Are these available on Thingiverse?

]]> Fri, 01 Aug 2014 03:12:23 +0000 https://www.soliforum.com/post/61664/#p61664 <![CDATA[Solidoodle risers to store power supplies]]> https://www.soliforum.com/post/61434/#p61434 I made these risers so I could mount power supplies to the bottom of my SD3 . They raise it up 5 inches ,are built to be very robust. I printed them at.3mm and .2 infill feed rate 120 % . They take 13 + hours each to print. I then glued Neo magnets to the tops and small rubber feet to the bottoms.



If I can figure it out I will post picture

]]> Tue, 29 Jul 2014 20:10:32 +0000 https://www.soliforum.com/post/61434/#p61434