<![CDATA[SoliForum - 3D Printing Community — Z axis not moving enough]]> https://www.soliforum.com/topic/7090/z-axis-not-moving-enough/ Fri, 25 Jul 2014 21:22:45 +0000 PunBB <![CDATA[Re: Z axis not moving enough]]> https://www.soliforum.com/post/61212/#p61212 Yep go back and change your steps in EEPROM.  When you re flash it goes back to what is in the firmware.

]]> Fri, 25 Jul 2014 21:22:45 +0000 https://www.soliforum.com/post/61212/#p61212 <![CDATA[Z axis not moving enough]]> https://www.soliforum.com/post/61211/#p61211 Just printed a part and it is about half as tall as it should be. X and Y seem fine.

Have checked EEPROM and it is correct.

I have installed an M5 Z axis and set up correctly months ago. I have just installed a gcode controlled fan which involved reflashing firmware and now it is doing this.

Any ideas?

]]> Fri, 25 Jul 2014 20:44:06 +0000 https://www.soliforum.com/post/61211/#p61211