<![CDATA[SoliForum - 3D Printing Community — Unable to reach 250 degrees]]> https://www.soliforum.com/topic/7028/unable-to-reach-250-degrees/ Mon, 21 Jul 2014 03:44:21 +0000 PunBB <![CDATA[Re: Unable to reach 250 degrees]]> https://www.soliforum.com/post/60858/#p60858 Thanks guys! It is all working great.

]]> Mon, 21 Jul 2014 03:44:21 +0000 https://www.soliforum.com/post/60858/#p60858 <![CDATA[Re: Unable to reach 250 degrees]]> https://www.soliforum.com/post/60785/#p60785 Yep... Make the changes in firmware and then run at 240 - 250 for ABS

]]> Sun, 20 Jul 2014 06:04:43 +0000 https://www.soliforum.com/post/60785/#p60785 <![CDATA[Re: Unable to reach 250 degrees]]> https://www.soliforum.com/post/60759/#p60759 elmoret wrote:
exineport wrote:

A little toasty for abs IMHO. I run 205-215 (maybe at most 220 to get those layers together) but I'm pretty new still.

You're using a completely different hotend which measures temperature in a different location.

My bad, disregard.

]]> Sat, 19 Jul 2014 23:24:35 +0000 https://www.soliforum.com/post/60759/#p60759 <![CDATA[Re: Unable to reach 250 degrees]]> https://www.soliforum.com/post/60756/#p60756 exineport wrote:

A little toasty for abs IMHO. I run 205-215 (maybe at most 220 to get those layers together) but I'm pretty new still.

You're using a completely different hotend which measures temperature in a different location.

]]> Sat, 19 Jul 2014 23:21:29 +0000 https://www.soliforum.com/post/60756/#p60756 <![CDATA[Re: Unable to reach 250 degrees]]> https://www.soliforum.com/post/60751/#p60751 A little toasty for abs IMHO. I run 205-215 (maybe at most 220 to get those layers together) but I'm pretty new still.

]]> Sat, 19 Jul 2014 23:08:11 +0000 https://www.soliforum.com/post/60751/#p60751 <![CDATA[Re: Unable to reach 250 degrees]]> https://www.soliforum.com/post/60723/#p60723 Sounds to me like you never flashed the board like you were supposed to. That also means you've ben running on the wrong thermistor setting.

Good times.

]]> Sat, 19 Jul 2014 20:06:28 +0000 https://www.soliforum.com/post/60723/#p60723 <![CDATA[Unable to reach 250 degrees]]> https://www.soliforum.com/post/60721/#p60721 I have been printing with PLA since I got the printer, so I set my printer to 210 and that worked out fine. Once I got some ABS, I tried printing at 250. The printer would go fine until it reached 236 and the it would stop and start to drop. I am using a e3d v6 and the original solidoodle board.

]]> Sat, 19 Jul 2014 19:53:01 +0000 https://www.soliforum.com/post/60721/#p60721