<![CDATA[SoliForum - 3D Printing Community — i don't know what happened!!]]> https://www.soliforum.com/topic/6937/i-dont-know-what-happened/ Fri, 11 Jul 2014 18:37:41 +0000 PunBB <![CDATA[Re: i don't know what happened!!]]> https://www.soliforum.com/post/60197/#p60197 i have tried clicking both direction just to make sure! I will try unplugging the Z axis and plugging it back in. I will reply back here in a few minutes!


Yep everything else works.. i can move the extruder Left, right, forward, and backwards. its just the build platform that doesnt want to move unless i click the Home button.

]]> Fri, 11 Jul 2014 18:37:41 +0000 https://www.soliforum.com/post/60197/#p60197 <![CDATA[Re: i don't know what happened!!]]> https://www.soliforum.com/post/60063/#p60063 By clicking to move it down, you are actually clicking the up arrow, right?  Keep in mind solidoodle's are reversed.  Disconnect, reconnect, home Z then try it again.  Might take a couple tries because if the printer somehow "forgets" where the Z axis is at in relation to home, it won't move it. 

Does everything else work?

]]> Thu, 10 Jul 2014 15:18:33 +0000 https://www.soliforum.com/post/60063/#p60063 <![CDATA[Re: i don't know what happened!!]]> https://www.soliforum.com/post/60050/#p60050 after reading this post, I am determined to buy a good u.p.s.

]]> Thu, 10 Jul 2014 06:59:30 +0000 https://www.soliforum.com/post/60050/#p60050 <![CDATA[Re: i don't know what happened!!]]> https://www.soliforum.com/post/60020/#p60020 Nope! Didn't help sad It is still doing the same

]]> Wed, 09 Jul 2014 20:43:06 +0000 https://www.soliforum.com/post/60020/#p60020 <![CDATA[Re: i don't know what happened!!]]> https://www.soliforum.com/post/60018/#p60018 Click "Disconnect" then reconnect in RH. I have this problem constantly. For me, it's no big deal, but I hope this helps.

]]> Wed, 09 Jul 2014 20:08:38 +0000 https://www.soliforum.com/post/60018/#p60018 <![CDATA[i don't know what happened!!]]> https://www.soliforum.com/post/60015/#p60015 I was out of town for 45 minutes while my print was finishing. During this time a storm blew into town and has obvious knocked out the power to my house. My SD2 is protected by an awesome surge protector! When i attempt to click to move the Z axis up or down it does not move.
However, when i click the home button for the Z axis it moves down some and up some until it parks. I then try clicking again to move the Z axis down and it doesn't move. It seems only clicking the Z axis home button is moving it!

Any suggestions would be awesome!!

Thank you smile

]]> Wed, 09 Jul 2014 19:41:10 +0000 https://www.soliforum.com/post/60015/#p60015