<![CDATA[SoliForum - 3D Printing Community — Shaft collar rubbing on flange]]> https://www.soliforum.com/topic/6932/shaft-collar-rubbing-on-flange/ Wed, 09 Jul 2014 23:55:32 +0000 PunBB <![CDATA[Re: Shaft collar rubbing on flange]]> https://www.soliforum.com/post/60028/#p60028 Ahh gotcha, I understand now. Thank you!!

]]> Wed, 09 Jul 2014 23:55:32 +0000 https://www.soliforum.com/post/60028/#p60028 <![CDATA[Re: Shaft collar rubbing on flange]]> https://www.soliforum.com/post/59995/#p59995 Post a few photos of what you have so far. Can the auger slide back and forth? Most likely, you are misinterpreting the instructions. Only one thrust bearing is needed, since pressure from the plastic will drive the shaft collar away from the flange that is connected to the barrel.

]]> Wed, 09 Jul 2014 14:40:06 +0000 https://www.soliforum.com/post/59995/#p59995 <![CDATA[Shaft collar rubbing on flange]]> https://www.soliforum.com/post/59988/#p59988 Hi folks,

I have a filastruder v1.5. I have followed the instructions up until step 6. At this point, I observed that the bearings are on the opposite side of the flange, and thus the shaft collar rubs directly against the flange. Realizing this can't be right, I turn to you for help.

Thanks!

]]> Wed, 09 Jul 2014 04:32:34 +0000 https://www.soliforum.com/post/59988/#p59988