https://www.soliforum.com/topic/6902/level-the-bed-with-the-wingnuts/ Fri, 04 Jul 2014 17:40:40 +0000 PunBB https://www.soliforum.com/post/59786/#p59786 If your printer has the wingnuts, you can just turn them to level the bed.  The video is a bit dated!

]]> Fri, 04 Jul 2014 17:40:40 +0000 https://www.soliforum.com/post/59786/#p59786 https://www.soliforum.com/post/59784/#p59784 Newbie question here.  The official Solidoodle leveling video says to poke holes in the kapton and run the three bed screws in.  But then I noticed that the printer in the video doesn't have wingnuts on the bottoms of those screws and my printer does.  Can't I just tighten/loosen the wingnuts to lower/raise the bed, or am I missing something?

]]> Fri, 04 Jul 2014 17:19:06 +0000 https://www.soliforum.com/post/59784/#p59784