<![CDATA[SoliForum - 3D Printing Community — Nylon flexibility]]> https://www.soliforum.com/topic/6881/nylon-flexibility/ Thu, 03 Jul 2014 10:55:23 +0000 PunBB <![CDATA[Re: Nylon flexibility]]> https://www.soliforum.com/post/59698/#p59698 I also found out that, even though it is not the same, the plastic industry also uses the Flexural Modulus:
http://www.efunda.com/forum/show_messag … amp;id=825

]]> Thu, 03 Jul 2014 10:55:23 +0000 https://www.soliforum.com/post/59698/#p59698 <![CDATA[Re: Nylon flexibility]]> https://www.soliforum.com/post/59697/#p59697 Thank you guys! That's exactly what I was looking for!

]]> Thu, 03 Jul 2014 10:41:48 +0000 https://www.soliforum.com/post/59697/#p59697 <![CDATA[Re: Nylon flexibility]]> https://www.soliforum.com/post/59684/#p59684 elmoret wrote:

Young's modulus.

Low = flexible
High = stiff

smile

]]> Thu, 03 Jul 2014 05:20:27 +0000 https://www.soliforum.com/post/59684/#p59684 <![CDATA[Re: Nylon flexibility]]> https://www.soliforum.com/post/59653/#p59653 Young's modulus.

]]> Wed, 02 Jul 2014 20:18:00 +0000 https://www.soliforum.com/post/59653/#p59653 <![CDATA[Nylon flexibility]]> https://www.soliforum.com/post/59650/#p59650 Hello everyone!

What parameter should I use to measure if a Nylon filament is going to be more flexible than other?

Like Nylon6, 6.6 , 11... 12?

Thank you! Best Regards.

]]> Wed, 02 Jul 2014 19:27:15 +0000 https://www.soliforum.com/post/59650/#p59650