<![CDATA[SoliForum - 3D Printing Community — Dial indicator question]]> https://www.soliforum.com/topic/6594/dial-indicator-question/ Sat, 31 May 2014 14:58:37 +0000 PunBB <![CDATA[Re: Dial indicator question]]> https://www.soliforum.com/post/57519/#p57519 That's what I was thinking. I'm just trying to swap different print surfaces as lazy as possible.

I will have to open an off shore bank account to slide the board and dog past the wife big_smile

]]> Sat, 31 May 2014 14:58:37 +0000 https://www.soliforum.com/post/57519/#p57519 <![CDATA[Re: Dial indicator question]]> https://www.soliforum.com/post/57517/#p57517 My vote is save your cash! spend it on a Rumba or a bulldog XL wink

]]> Sat, 31 May 2014 14:35:36 +0000 https://www.soliforum.com/post/57517/#p57517 <![CDATA[Dial indicator question]]> https://www.soliforum.com/post/57509/#p57509 I have never used one, so my possibly-stupid question is as follows:
Can I use a dial indicator for z height? I ask because I am testing out some new print surfaces and would like to record height settings on each for faster adjustments.

I understand most use them for bed leveling, but is this a capital idea or should I just save my cash?

]]> Sat, 31 May 2014 13:59:32 +0000 https://www.soliforum.com/post/57509/#p57509