<![CDATA[SoliForum - 3D Printing Community — Skeinforge Slicing Problem]]> https://www.soliforum.com/topic/656/skeinforge-slicing-problem/ Wed, 28 Nov 2012 13:06:08 +0000 PunBB <![CDATA[Re: Skeinforge Slicing Problem]]> https://www.soliforum.com/post/5800/#p5800 How thick is the keyway?  If you play with the infill settings (just for giggles, set it up at like .9 and reslice, but I would NOT suggest printing there!) does it fill up?  I think the "Infill width over thickness" setting might also alter how big of an interior gap the slicer decides to apply infill to as well.  Basically open Skeinforge to the fill page and hit the little "?" and read thru the help per setting, try a few changes out, see what gives you what you want.

]]> Wed, 28 Nov 2012 13:06:08 +0000 https://www.soliforum.com/post/5800/#p5800 <![CDATA[Skeinforge Slicing Problem]]> https://www.soliforum.com/post/5766/#p5766 Attempting to print a shaft coupling.

https://dl.dropbox.com/u/1786359/21.png

The shaft has a split down the middle, so I'm printing a hole with a full width keyway, if that makes sense. The keyway does not print solid, it has 2-3 layers, a gap, and 2-3 layers.

The perimeters are set to 5, and the outside perimeter of the object does indeed have 5 layers.

What am I doing wrong? There's gotta be a setting for this. I just want that vertical part to print solid!

Thanks!

]]> Tue, 27 Nov 2012 23:40:44 +0000 https://www.soliforum.com/post/5766/#p5766